Skip to main content
Version: 4.6.0

Liquify

Liquify gives you the freedom to control the proportions of multiple facial and body features.

properties

Add a Liquify Component

Add a Liquify component by clicking + Add Component > Utility > Liquify in the Inspector panel.

Properties

PropertyDescription
SymmetryChecking this box will apply the liquify evenly to both sides of the face.
RadiusDetermines the radius of the liquify circle. Use the slider to set the radius to a value between 0 and 3. The default value is 1. See the demonstration below.
Intensity XDetermines the amount of vertical compression along the x-axis for the liquify circle. Use the slider to set the intensity to a value between -1 and 1. The default value is 0.5. See the demonstration below.
Intensity YDetermines the amount of horizontal compression along the x-axis for the liquify circle. Use the slider to set the intensity to a value between -1 and 1. The default value is 0.5. See the demonstration below.
Liquify AreaChoose what part of the liquify circle the effect is applied to. See the demonstration below.
  • Full (default) enables the Liquify effect on the entire circle.
  • Left, Right, Up, and Down enable the Liquify effect on the selected half of the circle.

Demonstrations

Radius

radius

Intensity X

intensity x

Intensity Y

intensity y

Liquify Area

full   left   right
up   down